Lobob Optimum Cleaning Disinfecting Storage Solution

Ingredients

Lauryl Sulfate Salt of Imidazoline; Octylphenoxypolyethoxyethanol; Preservatives: Benzyl Alcohol 0.3%; Disodium Edetate 0.5%

Dosage

GENERAL: Always wash and rinse your hands before handling your contact lenses. Clean and store your lenses in Optimum CDS after each removal. To avoid lens mixup, always clean your right lens first and your left lens last. Optimum CDS is not for use directly in the eye. CLEAN: Remove right lens and place in palm of hand. Cup hand and cover lens completely with 10 drops of Optimum CDS Solution. Rub lens for 30 seconds using the index finger of the other hand creating a sudsy pool of solution. Note: The greater the sudsing action, the better the cleaning performance. Rinse the lens thoroughly with running cold tap water. To protect against loss, always close sink drain when cleaning lenses. DISINFECT: Place the lens in the right chamber of your lens storage case and completely cover the lens with Optimum CDS Solution. Repeat the procedure with your left lens. STORE: Close the lens storage case and store lenses in the unopened case for at least six (6) hours. TO REINSERT: Remove the right lens from the lens storage case, and rinse thoroughly as directed by your eye care practitioner. All Optimum CDS Solution MUST be completely removed from the lens before insertion. Apply 2 drops of a lubricating and wetting solution such as Optimum WRW to all surfaces of the lens and place the lens in the eye. Repeat the procedure with the left lens. IMPORTANT SAFETY INFORMATION AND DIRECTIONS PRINTED ON INSIDE OF BOX. PLEASE SAVE FOR FUTURE REFERENCE.

Warning

Please note carefully the ingredients as listed. If you are allergic to any ingredient in Optimum CDS Solution, do not use this product. Keep out of reach of children. Not for use with soft (hydrophilic) lenses. To avoid contamination, do not touch dropper tip to any surface. Replace cap after each use. Optimum CDS Solution is NOT for use directly in the eye. Optimum CDS Solution must be completely rinsed from the lenses after disinfection and prior to wetting and insertion.