Dentemp O.S. One Step Filling Dental Repair Material Maximum Hold

Ingredients

Calcium Sulphate; Barium Sulphate; Dimethoxytetraethylene Glycol; Zinc Oxide; Eugenol; Ethylmethacrylate Polymer

Dosage

To replace a lost filling: Wash hands thoroughly. Rinse out cavity with warm water. Do not dry; leave moist. Use applicator to remove a small amount of material from vial, form into a ball with your fingers and press firmly into cavity. Bite down several times to insure proper bite. Remove any excess material. Rinse out mouth well with water. Allow 1 hour to set before eating. To re-cement loose caps or crowns: Wash hands. Prepare crown by carefully removing as much old cement as possible from inside of the crown. Rinse well. Clean and rinse tooth area with water and leave moist. Fit the crown back on the tooth before applying product. Make sure it fits properly. If you cannot do this, do not proceed. See your dentist. Use applicator to remove a small amount of material from vial. Place a thin layer of material (the thickness of 2-3 sheets of paper) on the upper inside wall of the crown. Place crown on wet tooth and press firmly. Bite down several times to insure proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal. Remove any excess material. Rinse out mouth well with water. Allow at least 1 hour to set before eating. When replacing a bridge apply product sparingly to only 1 hollow tooth at each end of the bridge. Should not be used on implants or posts without dentists advice. Keep multi-use vial closed to maintain freshness of remaining material.

Warning

READ DIRECTIONS CAREFULLY BEFORE USING. KEEP OUT OF REACH OF CHILDREN. This product should not be used if throbbing pain or swelling in affected area exists. Consult your dentist immediately. This product is sold as a temporary remedy. See your dentist as soon as possible for permanent work to be performed. Failure to do so may cause infections and/or serious injury. Wash hands before using.