Product Description

More Wafers
Better Value
No Ooze
Zinc-Free
Holds Tight

Product Benefits

Ingredients

Suggestions

Directions: 1. Place dry wafer on denture. If too large, trim overlapping wafer with scissors. 2. Clean denture thoroughly. Moisten wafer with warm water, but do not saturate. 3. Position moistened wafer with white side up. Smooth wrinkles with finger. 4. Place dentures into mouth. Hold firmly until secure. If wafer does not hold, add a little more water to wafer. Again, do not saturate wafer. 5. To remove wafer from denture, lift corner and peel away. Change wafer daily.

Special Note

Warnings

If irritation occurs, discontinue use. Poorly fitting dentures may impair health and interfere with the adhesive action of SEA-BOND. Consult dentist regularly. If you have a history of difficulty swallowing or choking, you should not use this product. Keep out of reach of children.

Disclaimers:

1. HerbsPro.com offers nationally branded products that are produced according to manufacturing standards set by regulators at everyday low prices. Do not use unproven, unbranded products, which can pose serious risks to your health.

2. California Proposition 65 WARNING: Some products on this website contains progesterone, a chemical known to the State of California to cause cancer. Consult with your physician before using this product

3. The statements made or products sold through this site have not been evaluated by the Food and Drug Administration (FDA) or by EU Health Authorities. They are not intended to diagnose, treat, cure, or prevent any disease. Read More

Sea-Bond, Sea-Bond Denture Adhesive Wafers Lowers, Fresh Mint 30 each