Product Description

A unique, no mix cement made especially for replacing loose caps and crowns. Tested safe and effective.

Product Benefits

Temporary Repair. Instant Pain Relief.

Ingredients



Suggestions

Directions: Prepare crown by carefully removing as much old cement as possible from inside the crown. Rinse well. Clean and rinse tooth area with water and leave moist. Fit the crown back on the tooth before applying recapit. Make sure it fits properly. If you cannot do this, do not proceed, see your dentist. Make sure inside of crown is dry. Open tube by reversing the cap and punching a hole in the tip of the tube. Apply a small amount of the material onto the upper inside edge of the crown. Remoisten tooth area, place crown on wet tooth and press firmly. Bite down several times to ensure proper fit. If the bite is not completely comfortable remove and repeat all steps until the crown feels normal. Wait 5 minutes and then gently remove any excess material. Rinse out mouth well with water. Allow at least 1 hour to set before eating. Cement will fully set in 1 to 3 hours. Note: when replacing a bridge apply recapit sparingly to only 1 hollow tooth at each end of the bridge. Recapit should not be used on implants or posts without a dentist's advice. Store at room temperature with container closed to keep material soft.

Special Note

Eugenol-Free

Warnings

Read directions carefully before using. Keep out of reach of children. This product should not be used if throbbing pain or swelling in affected area exists. Consult your dentist immediately. This product is sold as a temporary remedy. See your dentist as soon as possible for permanent work to be performed. Failure to do so may cause infections and/or serious injury.

California Proposition 65 WARNING

Some products on this website contains progesterone, a chemical known to the State of California to cause cancer. Consult with your physician before using this product.

Disclaimer

Herbspro.com offers nationally branded products that are produced according to manufacturing standards set by regulators at everyday low prices. Do not use unproven, unbranded products, which can pose serious risks to your health.